Electromechanical Coin Control - Primus DA11-15 Maintenance Manual

Operating Instructions

Electromechanical Coin Control

1. Set the TEMPERATURE selector at HIGH or
LOW, or anywhere between these settings.
2. Coin Drop Models: Insert the coin(s) in the coin
slot, turn the knob to the right and release it.
3. Press the PUSH TO START button and hold it for
approximately three (3) seconds.
14
TEMPERATURE
HIGH
LOW
PUSH
TO
START
Figure 6
1 2 3
SELECT INSERT PUSH
TEMP COIN START
INSERT QUARTER
TURN KNOB
25
IMPORTANT: If the loading door or lint panel
door is opened during the cycle, the heating system
will shut off and the motor will stop. However, the
timer will continue to run. To restart the cycle, both
doors must be closed and the PUSH TO START
button must be pressed in.
4. When the cycle is complete, open door and
remove the laundry.
TMB807N
70269601