Maintenance; Daily - Primus DA11-15 Maintenance Manual

To reduce the risk of electric shock, fire, explosion, serious injury or death:
• Disconnect electric power to the tumbler before servicing.
• Close gas shut-off valve to gas tumbler before servicing.
• Close steam valve to steam tumbler before servicing.
• Never start the tumbler with any guards/panels removed.
• Whenever ground wires are removed during servicing, these ground wires must be
reconnected to ensure that the tumbler is properly grounded.

Daily

Keep tumbler area clear and free from combustible
materials, gasoline, and other flammable vapors and
liquids.
Lint Removal
WARNING
To reduce the risk of serious injury, do not
open the lint panel while the tumbler is in
operation. Before cleaning the lint screen,
open tumbler door and allow cylinder to
completely stop.
1. Open the lint panel or pull out lint drawer.
2. Remove all accumulated lint in the lint
compartment area. Lightly brush any lint that
may be left on the lint screen. Lint left in the lint
compartment is drawn back onto the lint screen
and will restrict proper air circulation.
70269601

Maintenance

WARNING
3. Be sure the lint screen is not torn. If it is, replace
4. The lint screen is designed to completely cover
5. Carefully wipe any accumulated lint off of the
W410
6. Replace the lint compartment panel on the
immediately. A torn lint screen allows lint to pass
from the tumbler to the ductwork system, thus
creating a restriction to air circulation.
the entire opening in the lint screen panel. Be
sure that it does so. Excessive gaps between the
lint screen and the lint screen panel allow lint to
pass into the ductwork system.
thermostat sensing probe, cabinet high limit
thermostat and thermistor. Failure to do so will
allow a buildup of lint in this area to act as an
insulator, causing the tumbler to overheat. Refer
to Figure 12.
tumbler ensuring a tight fit, and lock if
applicable.
W002
21