Electronic Opl Control - Primus DA11-15 Maintenance Manual

Electronic OPL Control

1. To use an Automatic Cycle, press an ON/
SELECT pad. Select HIGH, MEDIUM,
MED LOW, LOW or NO HEAT for items that
should not be dried with heat. A light to the left
of the selected pad lights up.
To use a Time Dry or Custom Cycle, refer to the
Programming Manual.
NOTE: Do not press directly on lights or the center
of pad. For proper selection, press on pad slightly
to the right of center. Refer to Figure 5.
Figure 5
70269601
ON / SELECT
HIGH
START
MEDIUM
STOP/RESET
MED LOW TEMP
DISPLAY
F/ C
LOW SIGNAL
NO HEAT
Figure 4
TMB806N
TMB806N
STATUS PROGRAM
AUTO
DRYING
AUTO
SPECIAL
COOL DOWN
CYCLE
*
AUTO
TEMP
DOOR OPEN
CUSTOM
MORE
+
CONDITION
2. Press START pad to start tumbler.
NOTE: All pads can be pressed in any sequence
without damaging control or tumbler. To stop the
tumbler at any time, open the door or press STOP/
RESET. The window display will flash. Press
STOP/RESET twice (within 3 seconds) to end the
cycle and reset the control to idle status. To restart
the tumbler, CLOSE door and press START pad.
IMPORTANT: If the loading door or lint panel
door is opened during the cycle, the heating system
will shut off and the motor will stop. To restart the
cycle, both doors must be closed and the PUSH TO
START button must be pressed in.
3. When the cycle is complete, open door and
remove the laundry.
Operating Instructions
TIME
SPECIAL
TIME
*
COOL
DOWN
LESS
- -
SAVE
CUSTOM
PROG
TMB1789N
TMB1789N
13