Configure Snmp Access; Front Panel Indicator Lights; Connect To The Barracuda Control Server - Barracuda Control Server Administrator's Manual

Click Save Changes.

Configure SNMP Access

You can configure SNMP access between the Barracuda Control Server and an SNMP monitor or
other program used to query for system information on the

Front Panel Indicator Lights

The Barracuda Control Server has five indicator lights on the front panel that blink when the system
processes any message. Figure 2.1 displays the location of each of the lights.
Figure 2.1: Barracuda Control Server front panel indicator lights

Connect to the Barracuda Control Server

You can connect one or more Barracuda Networks products to a Barracuda Control Server by doing
the following:
Log into the Barracuda Control Server web interface as the Barracuda Control Server Account
1.
Admin.
The
2.
are connected.
Go to the
3.
In another browser window, log into the product you wish to connect to the Barracuda Control
4.
Server as the administrator. From the product
14 Barracuda Control Server Administrator's Guide
If the Barracuda Control Server is behind a proxy server, enter the proxy server IP
3c.
address and port number, and if required, enter the proxy server username and password
in the Proxy Server Configuration section.
Enter the default domain name of the Barracuda Control Server in the Domain
3d.
Configuration section.
Whenever your Barracuda Control Server IP address is changed on the
page, you are disconnected from the administration interface. You must log in again using
the new IP address.
CLOUD CONTROL > Status
CLOUD > Connect Products
CLOUD CONTROL > Administration
page displays, including a message indicating that no products
page, and copy the Validation Token.
ADVANCED > Firmware Upgrade
IP Configuration
page.
page, check to