Initial Setup; Prepare For Installation; Connect Barracuda Control Server To Network - Barracuda Control Server Administrator's Manual

Initial Setup

These are the steps to set up your Barracuda Control Server.

Prepare for Installation

Before installing your Barracuda Control Server, verify you have the necessary equipment; if any
item is missing or damaged, please contact your Barracuda Networks Sales representative:
• Barracuda Control Server
• AC power cord
• Mounting rails
Also required for installation:
• Ethernet cables
• VGA monitor (recommended)
• PS2 keyboard (recommended)

Connect Barracuda Control Server to Network

To physically install the Barracuda Control Server:
Fasten the Barracuda Control Server to a standard 19-inch rack or other stable location.
1.
Caution
Do not block the cooling vents located on the front and rear of the unit.
Connect a CAT5 or CAT6 Ethernet cable from your network switch to the Ethernet port on the
2.
back of your Barracuda Control Server.
The Barracuda Control Server supports both 10BaseT and 100BaseT Ethernet. Barracuda
Networks recommends using a 100BaseT connection for best performance.
Do not connect any other cables to the other connectors on the unit. These connectors are for
diagnostic purposes.
Connect a standard VGA monitor, PS2 keyboard, and the AC Power Cord to the appliance.
3.
AC input voltage range is 100-240 volts at 50/60 Hz.
After you connect the AC power cord the Barracuda Control Server may power on for a few
seconds and then power off. This is standard behavior.
Press the
4.
The login prompt for the administrative console displays on the monitor, and the light on the
front of the system turns on. For a description of each indicator light, refer to Front Panel
Indicator Lights.
12 Barracuda Control Server Administrator's Guide
button located on the front of the unit.
Power