Configure Ip Address And Network Settings; Network Path; Configure Your Corporate Firewall; Configure The Barracuda Control Server Administrative Settings - Barracuda Control Server Administrator's Manual

Configure IP Address and Network Settings

To set an IP address from the administrative console:
Connect your keyboard and monitor directly to the Barracuda Control Server.
1.
At the
2.
barracuda login
The User Confirmation Requested window displays the current IP configuration of the
Barracuda Control Server.
Using your Tab key, select
3.
Enter the new IP address, netmask, and default gateway for your Barracuda Control Server.
4.
Select
Save
The new IP address and network settings are applied to your Barracuda Control Server.

Network Path

Barracuda devices you wish to manage through the Barracuda Control Server must have a network
path between the two devices and at least one of the following ports available to communicate
between the devices: port 80, 8000, 23557, or 48320.

Configure Your Corporate Firewall

If your Barracuda Control Server is located behind a corporate firewall, you may need to open ports
1194 and ports 5120-5129 outbound for both TCP and UDP to allow communication between the
Barracuda Control Server and the Internet.
These ports are used to transfer data either to the Barracuda Control Server, or to another Barracuda
Networks appliance over the Internet. To restrict outbound network traffic on these ports, contact
Barracuda Networks Technical Support for a list of the IP addresses to allow.

Configure the Barracuda Control Server Administrative Settings

After specifying the IP address of the Barracuda Control Server, configure the Barracuda Control
Server from the administration interface.
To configure administrative settings on the Barracuda Control Server:
From a web browser, enter http:// followed by the IP address of the Barracuda Control Server,
1.
followed by the default web interface HTTP Port (:8000).
For example:
Log into the administration interface using admin for both the username and password.
2.
Go to
3. CLOUD CONTROL > IP Configuration
In the TCP/IP Configuration section, verify the IP address, netmask, and default
3a.
gateway for your Barracuda Control Server (entered in step 4. above in the Configure
IP Address and Network Settings section).
In the DNS Configuration section, enter the IP address of your primary and secondary
3b.
DNS servers (if these have not yet been set up).
prompt, enter admin for the login and admin for the password.
and press
Change
to enter your changes. Select
http://192.168.200.200:8000
to change the IP configuration.
Enter
.
Exit
, and perform the following steps:
Using the Barracuda Control Server 13