Black & Decker GL650 User Manual page 11

Never use a light socket.
Using an extension cable
Always use an approved extension cable suitable
for the power input of this appliance (see rating
plate). The extension cable must be suitable for
outdoor use.
Before use, inspect the cable for signs of
damage, wear and ageing. Replace the
extension cable if damaged or defective.
When using a cable reel, always unwind the
cable completely.
Take care to keep the cable away from the
cutting line. Always be aware of the position of
the cable.
CARTON CONTENTS
The carton contains:
1 Grass trimmer
1 Guard with mounting screw
1 Plant protector incl. parts pack
(GL660P/GL670P only)
1 Instruction manual
Carefully unpack all parts.
OVERVIEW (fig. A)
1. On/off switch
2. Handle
3. Cable restraint
4. Power inlet (not for UK)
5. Secondary handle
6. Handle button (GL670/GL670P)
7. Locking ring
8. Cable storage hooks
9. Motor housing
10. Pedal (GL670/GL670P)
11. Guard
12. Line trimming blade
13. Edge guide
14. Spool housing
15. Cutting line
ASSEMBLY
Before assembly, make sure that the tool
is switched off and unplugged.
Fitting the guard (fig. B)
Unplug the tool.
Remove the screw (16) from the housing.
Place the guard (11) onto the tool as shown.
Firmly press the guard until it snaps into place.
Secure the guard with the screw (16).
Never use the tool unless the guard is
properly fitted.
Releasing the cutting line (fig. A)
In transit, the cutting line is taped to the spool
housing.
Remove the tape holding the cutting line (15)
to the spool housing (14).
Fitting the plant protector (fig. C)
The plant protector is supplied as a standard
accessory with the GL660P & GL670P. For other
models, it is available as an optional accessory.
Place the plant protector (17) over the guard as
shown. Make sure that the orientation is correct.
Place the two plastic caps (18) onto the plant
protector, aligning any of the marks (19) on the
caps with those on the guard (11).
Secure the caps using the screws (20).
Do not overtighten the screws.
Wait until the cutting line has come to a
standstill before adjusting the plant
protector.
Connecting the tool to the mains (fig. A)
Connect the female plug of a suitable
extension cable to the power inlet (4).
Loop the cable through the cable restraint as
shown in fig. O.
Insert the mains plug into a mains outlet.
The extension cable must be suitable for
outdoor use.
USE
Let the tool work at its own pace. Do not
overload.
E N G L I S H
11