Fuse Replacement - Sony XM-1600GSD Operation Instructions Manual

Speaker lead direct in connector
Cordon de haut-parleur directement dans le connecteur
*I
Left speaker
Haut-parleur gauche
/
Car audio
F Right speaker
Haut-parleur droit
Autoradio
Black-striped lead
Cordon ray@ noir
Flat-head screwdriver
Tournevis 5 lame plate
Lead diameter 0.3 - 1.25 mm (AWG 22 - 16)
Section du cordon : 0,3 - 1.25 mm (AWG 22-16)
'/I6 (11)
Unit : in. (mm)
Unit@ : po. (mm)
Precaution
*This unit is dcsigncd for negative ground 72 V
DC operation
c>nly.
l
Use
speakers with suitable impedance.
- 1
to8Q.
m Do not connect any ;Ictive speakers (with built-in
;Implifiers) to the speaker terminals of the unit.
Doing so may damage the actilre speakers.
* A\,oid installing the unit where:
- it
u~~~ild be subject to high temperatnrcs such
as from direct sunlight or hot air from the
heater
~ it would be exposed to rain or moisture
~ it would bc subject
to
dust or dirt.
l
If your car is parked in direct sunlight and there
is a considerable rise
in
tcmperaturc inside the
car, allow the unit to cool down before USC.
* When installing the unit horizontally, be sure not
to cover the fins with the floor carpet etc.
l
If this unit is PIaced
too
close to the car
radio,
interference may occur. In this case, relocate th<>
amplifier away from the car radio.
l
If no power is being supplied to the master unit,
check the connections.
@ This power amplifier etnplovs a protection
circuit':' to protect the transistors and spcakcrs if
the amplifier mAfunctions. Do
not
attempt to test
the protection circuits by covering the heat sink
or connecting improper loads.
l
Do not use the unit on a weak battery as its
optimum performance depends on a good power
suPPlY.
l
For safety reasons, keep your car audio volume
moderate so that you can still hear
sounds
outside your car.
Fuse Replacement
If
the fuse blows, check the
po~w- connection and
replace the fuse, It the fuse blows again after
replacement, thcrc ma\. be an internal malfunction.
In such <I cast, c~nsult~you~- nearest Sony dealer
Warning
When replacin,
0 tl-w fusv, hc sure tc) LI~C' one
matching the amperage stated abo\*c the fuse
holder. Never use a
fuse with an
amperage rating
exceeding the one supplied with the unit as this
could
damage
the unit.