8.
Disassembling "PE SWITCH ASSY"
Remove "SCREW, PHT (BT#3), M1.7 × 6" that fastens "SA, FRAME BASE" and "PE SWITCH ASSY".
SCREW, PHT (BT#3), M1.7 × 6
<Precaution at reassembly>
When reassembling, align the screw and the boss with the holes for them, respectively, then tighten the
screw.
Keep the cable away from the frame.
9.
Disassembling "SA, FRAME BASE"
Remove two "SCREW, PHT (ST#3), M3.0 × 6" that fasten "SA, FRAME BASE R & L".
Remove "E-RING, 2.0" and detach "GEAR1, REDUCTION" from "SA, FRAME BASE R". Then remove
"REDUCTION GEAR".
SCREW, PHT (ST#3), M3.0 × 6
<Precaution at reassembly>
Align the bosses at "SA, FRAME BASE L" with the holes at "SA, FRAME BASE R".
10. Disassembling "MOTOR ASSY"
Remove "SCREW, PHT (ST#3), M3.0 × 6" that fastens "SA, FRAME BASE R" and "MOTOR ASSY".
Hole for screw
Hole for boss
Hole for boss
MOTOR ASSY
- 15 -
CT-292/293 Series Service Manual
REDUCTION GEAR
Keep the cable away
from the frame.
E-RING 2.0
GEAR1, REDUCTION