Citizen CT-P292 Series Service Manual page 13

CT-292/293 Series Service Manual
<Precaution at reassembly>
When reassembling, insert "PLATEN", together with "PLATEN BUSHING", into "FRAME, FRONT DOOR"
from the right. Since the shaft length of "PLATEN" differs between the right and left, be careful not to insert
"PLATEN" in a wrong orientation.
4. Disassembling "AUTO CUTTER" (CT-P293) or "DUMMY, CUTTER FRAME" (CT-P292)
Remove two "SCREW, PHT (ST#3), M3.0 × 6", that fasten "FRAME, FRONT DOOR", from the right and
left sides.
Slide "CUTTER" or "DUMMY, CUTTER FRAME", and remove it while holding the side frames of
"FRAME, FRONT DOOR" outwardly.
<Precaution at reassembly>
When reassembling, pull "FRAME, FRONT DOOR" outwardly and slide "CUTTER" or "DUMMY, CUTTER
FRAME" onto "FRAME, FRONT DOOR" from a slanting direction.
Align the holes with the internal bosses at the right and left sides of "FRAME, FRONT DOOR".
Check the mounting orientation. (The paper guide faces the "PLATEN" side.)
BOSS
SCREW, PHT (ST#3), M3.0 × 6
Check the orientation.
Left side
- 12 -
BOSS
Left side