Britax Expressway ISOFIX User Manual page 9

Installation
5 Pull the shoulder portion of the
seat belt tightly through the lock-
off to remove slack ( Fig. D ).
Hold the shoulder belt tight, then
6 6
flip the lock-off arm up until a pos-
itive click is heard ( Fig. E ).
IMPORTANT: Lock-off is not
engaged and vehicle belt is not
secured until a click is heard when
closing the lock-off.
7 Verify that the seat belt is tight
and the child restraint is secure.
See Checking Buckle Position on
Page 17.
Installation can be improved by the
use of the Versa-Tether ™
page 16 ).
R R e e m m o o v v a a l l
To remove the child restraint, unfasten the seat belt and reverse the
above directions.
14
D
( see
E
A
B
C
Installation
F F o o r r w w a a r r d d F F a a c c i i n n g g
Lap Belt Installation
Figure A illustrates a typical lap belt
configuration.
NOTE: Protective cover should be
in place when LATCH is not in use.
1 Place the child restraint facing
forward on the vehicle seat.
2 Pass the seat belt through both
side slots.
3 3
Fasten the seat belt, then veri-
fy that the seat belt is not twisted
( Fig. B ).
Press child restraint into vehicle
4
seat, while removing slack from the
lap portion of the seat belt ( Fig. C ).
5 Verify that the seat belt is tight
and the child seat is secure.
See Checking Buckle Position on
Page 17.
Installation can be improved by the
use of the Versa-Tether
™
page 16 ).
R R e e m m o o v v a a l l
To remove the child restraint,
unfasten the seat belt and reverse
the above directions.
( see
15