Securing Y Y Our C C Hild - Britax Expressway ISOFIX User Manual

Securing Y Y our C C hild

Once the child restraint has been
installed in the vehicle, follow
these instructions to secure your
child in the child restraint.
1 Loosen the harness by pushing
the adjuster lever located in front
of the restraint, then pull the
shoulder straps forward ( Fig. A ).
2 Unfasten the chest clip by
squeezing the middle tab. ( Fig.
B ).
3 Unfasten the buckle by pressing
down on the middle button. ( Fig. C ).
4 Move the harness straps to the
side of the restraint. Use the hook
and loop fastener located on the
straps and side of the cover to aid
in holding the straps.
5 Place child in the restraint.
6 Position the harness straps
around the child and fasten the
child restraint buckle ( Fig. D ).
Proper connection is confirmed
with a positive click after inserting
the second buckle tongue.
20
A
B B
Unbuckle Buckle
C
7 Gently pull up on the harness
straps to tighten the lap section of
the harness, which should fit low
on your child's body ( Fig. D ).
8 Slowly pull the adjuster strap to
tighten the harness around the
child ( Fig. E ).
IMPORTANT: Harness should
have a comfortable, but SNUG, fit
around the child. A snug fit allows
you to place two fingers between
your child's body and the harness.
9 Fasten the chest clip by connect-
ing the two halves together.
IMPORTANT: The correct height
for the chest clip is at the middle of
the chest, level with the child's
armpit.
10 Verify that harness is not twisted
and child is properly secured.
See Checking Harness Height on
11
page 22.
Securing Y Y our C C hild
D
E
F
21