Care A A Nd M M Aintenance - Britax Expressway ISOFIX User Manual

Care a a nd M M aintenance

C C o o v v e e r r R R e e m m o o v v a a l l
1 Loosen the harness by pushing the harness release button while
pulling the shoulder straps forward as far as possible.
2 Unhook the shoulder straps from the yoke on the rear of child
restraint.
Remove the belly pad from the buckle.
3
4 Pull upper harness straps through the shell and cover, to the front
of the restraint.
Gently remove the upper portion of the cover. Be careful not to
5
damage the energy absorbing foam.
6 Pull the lower harness straps, buckle tongues, chest clip, buckle, and
belly pad through the slots in the cover.
WARNING:
• Do not take apart or attempt to take apart the harness. It is
unnecessary and dangerous to do so.
• Never remove the buckle tongues from the harness. They can-
not be reattached after removal.
7 Remove the entire cover from the restraint.
R R e e f f i i t t t t i i n n g g t t h h e e C C o o v v e e r r
To refit the cover, reverse Cover Removal directions. Make sure that
the shoulder straps are threaded through the chest clips and that
the harness is not twisted.
24
B B u u c c k k l l e e R R e e m m o o v v a a l l
1 Fully recline the child restraint.
2 Locate the metal buckle strap
retainer on bottom of the
restraint.
Pull retainer away from child
3
restraint to loosen.
4 Turn the retainer so that the short side will go through the slot
in the restraint shell ( Fig. A ).
5 Push the retainer through slots in the shell and cover, to the front
of the restraint.
R R e e t t h h r r e e a a d d i i n n g g t t h h e e B B u u c c k k l l e e
1 Locate the necessary buckle slot.
2 Turn the buckle retainer so that the short side will go through the
slot in the cover and restraint shell ( Fig. A ).
3 Pull buckle away from restraint until tight, then verify that the
strap is not twisted and the release button is facing outward.
Care a a nd M M aintenance
A
25