Power Supply Preparation; Ac Adaptor - Nextar Automative navigation system Instruction Manual

Power Supply
Preparation
Using the AC Adaptor
The unit is supplied with an AC adaptor for powering it and charging its battery.
1. Connect AC adaptor to the right
side of the unit in the jack
marked DC 5V IN, as shown on
the right.
2. Plug the two-prong end of the
power cord into a grounded
electrical outlet.
Note:
¾
Turn unit's power off before unplugging.
¾
In the case of using the adaptor, the LCD screen will be brighter than with the
rechargeable battery.
Using the Car Adaptor
The unit is supplied with a Car Adaptor for powering it while in a vehicle.
Connect the Car Adaptor Power Plug
to the unit's power jack and plug the
other end to the vehicle's 5V
accessory/ cigarette socket, as shown
on the right figure.
Attention
¾
Place the unit in a proper position for viewing.
¾
Disconnect the unit from the Car Adaptor when starting the vehicle.
Your portable GPS unit comes with a built-in rechargeable battery. Please see details in
the following segment.
10