TRENDnet TEG-082WS User Manual page 67

TRENDnet User's Guide
Add IPv6
To add an IPv6 policy, use the following procedure:

Click Add IPv6, The Policy Settings page.

Enter a number in the Policy Index field. The policy index is a unique
number within the range of 1 – 65535 which identifies the policy. This
field is mandatory.

Choose the parameters to add for the policy, and enter data one or
more of the parameters required for your policy. They are listed here:
o VLAN ID: A unique number identifying a VLAN ranging from
1 to 4094.
o 802.1p Priority: 802.1p priority level of the frame ranging
from 0 to 7.
o Protocol: Indicates the packet protocol ranging from 0 to 255.
o IPv6 Source IP Address: Specifies the IPv6 Source IP address.
o Prefix Length: Indicates the length of the Source IP ranging
from 1 to 128.
o IPv6 Destination IP Address: Specifies the IPv6 Destination
IP address.
o Prefix Length: Indicates the length of the Destination IP
ranging from 1 to 128.
o Source Layer 4 Port: Indicates the source layer 4 port ranging
from 1 to 65535.
o Destination Layer 4 Port: Indicates the destination layer 4
port ranging from 1 to 65535.
o Policy Sequence: Enter a number in the Policy Sequence field.
The Policy Sequence must be a unique number within the
range of 1 to 65535. This field is mandatory.
o Policy Action: In the Permit/Deny field, use the pull down
menu to select one of the following parameters:
© Copyright 2014 TRENDnet. All Rights Reserved.

Deny: This selection drops ingress packets that
conform to the specified Replaced-CoS or Replaced-
DSCP.

Permit: This selection allows ingress packets that
conform to the specified Replaced-CoS or Replaced-
DSCP to be processed by the switch.
Note: You must enter a selection for Deny/Permit field
even if the Profile Action ID that you have entered ignores
both the Replaced-DSCP and Replaced-CoS fields.
o Replaced-CoS: Enter a number in the Replaced-CoS field
ranging from 0 to 7. This field indicates the CoS level of
interest. This field is not mandatory and you may elect to
leave it blank
o Replaced-DSCP: Enter a number in the Replaced-DSCP field
within the range of 0 to 63. This field indicates the DSCP level
of interest. This field is not mandatory and you may elect to
leave it blank.
o Rate Control Index: The Rate Control Index is a unique
number within the range of 1 - 65535. This field is mandatory
and must match the Rate Control Settings page.
o Port List: Select the interface for which you want to display
data.

Click Add to add the policy to the Policy Table.
On the list, you can click Modify to modify an entry or click Delete or delete
the entry. You can also click Delete All to delete all of the entries in the table.
TEG-082WS
66