Fuel Gauge; Tire Pressure Monitoring System (Tpms); Function - Triumph Tiger 800 Owner's Handbook Manual

General Information

Fuel Gauge

1
cgjp_5
1. Fuel gauge
The fuel gauge indicates the amount of fuel
in the tank.
With the ignition switched on, the number of
bars shown in the display indicates the level
of fuel.
When the fuel tank is full all 12 bars are
displayed and when empty, no bars are
displayed. Other gauge markings indicate
intermediate fuel levels between full and
empty.
When 2 bars are displayed the low fuel
warning light will illuminate, 5 seconds later
the display screen will switch to 'Range'
display (see page 25). This indicates there are
approximately 1. 1 9 US gallons (4.5 liters) of
fuel remaining in the tank and you should
refuel at the earliest opportunity.
After refuelling, the fuel gauge and range to
empty information will be updated only while
riding the motorcycle. Depending on the
riding style, updating could take up to five
minutes.
30
Tire Pressure Monitoring
System (TPMS)
Note:
• TPMS is an accessory option on
Tiger 800 models only. It is not
available on Tiger 800XC models.

Function

Tire pressure sensors are fitted to the front
and rear wheels. These sensors measure the
air pressure inside the tire and transmit
pressure data to the instruments. These
sensors will not transmit the data until the
motorcycle is travelling at a speed greater
than 12 mph (20 km). Two dashes will be
visible in the display area until the tire
pressure signal is received.
The tire pressure monitoring system (TPMS)
is an accessory fitted item and must be fitted
by your authorized Triumph dealer. The
TPMS display on the instruments will only be
activated when the system has been fitted.
An adhesive label will be fitted to the wheel
rim to indicate the position of the tire
pressure sensor which is near the valve.