Gateway M460 Service Manual page 17

www.gateway.com
When loosening the cooling assembly's
screws in the numbered holes, loosen
them in reverse numerical order.
Important
The number of screws varies by model.
Loosen the six memory bay cover screws (these screws cannot be
3
removed), then remove the memory bay cover.
Use the thumb notch to lift the memory bay cover, then remove it. Be
4
careful not to break off the tabs located on the end of the cover opposite
of the thumb notch.
Loosen the three or four screws (these screws cannot be removed) that
Caution 5
secure the cooling assembly to the system board. Use the numbers
stamped in the metal next to each screw and loosen the screws in reverse
numerical order (start with 4, then 3, then 2, then 1).
Screws
Screw
Screw
Screw
Screw
Replacing the cooling assembly
13