Troubleshooting - Mahindra E2O Owner's Manual

9.6 TROUBLESHOOTING

PROBLEM
i. Start button pressed, car not turning on
with 'UNPLUG CAR' message.
ii. Car not switching on with message
'AUTHENTICATE KEY' on cluster.
iii. Car not switching on with SHIFT GEAR
TO 'N' message on cluster.
iv. Car not switching on with 'RESTART'
message on cluster.
v. Temperature Light comes on
while driving with 'GO SLOW' message
on cluster.
vi. Temperature Light comes on
while driving with 'STOP CAR'
message flashing on cluster.
vii. Car stopped in drive with 'CHARGE
CAR' message on cluster.
74
Starting & driving
POSSIBLE CAUSE
Charge cable may not be removed from
on board charge port.
Authentication not done correctly.
Car may not be parked in neutral.
Car may not have authenticated properly.
EV drive system temperature may have
reached max. operating limit.
EV drive system temperature may have
exceeded maximum operating limit.
Charge level of battery has dropped to 0%
SOC.
REMEDY
Remove charging cable from car on board
charge port.
Place remote key fob near 'START' button for
authentication.
Switch on, authenticate, move gear lever to
neutral and then to required mode.
Restart again and start your car.
Drive your car slowly and if on charge, stop
charging and allow 15-20 minutes to cool.
Park your car at safe place. Engage parking
brake. Wait for ~ 15 minutes till temperature
light goes off and start driving / charging
again.
Charge your car or activate REVive if
available.