Husqvarna ST 327T Operator's Manual page 9

MUF FLER
CHOKE CON TROL
THROTTLE
CON TROL
ON/OFF
SWITCH
PRIM ER
SAFETY IGNITION
KEY
FUEL SHUT-OFF VALVE
RECOIL STARTER HANDLE
NOTE: ITEMS ABOVE
ARE SHOWN IN
THEIR TYPICAL
LOCATION ON THE
ENGINE. ACTUAL
LOCATION MAY VARY
WITH THE ENGINE
ON YOUR UNIT.
MEETS A.N.S.I. SAFETY REQUIREMENTS
Our snow throwers conform to the standards of the American National Standards Institute.
Toolbox - used to store spare shear bolts, locknuts and
wrench.
Safety ignition key - must be inserted for the engine to
start and run. Remove when snow thrower is not in use.
Electric start button – used for starting the engine.
Recoil (auxiliary) starter handle – used for start ing the
en gine.
Primer - pumps additional fuel from the carburetor to the
cylinder for use when starting a cold engine.
Choke control - used for starting a cold engine.
ON / OFF switch - used to STOP the engine.
Throttle- used to se lect FAST or SLOW engine speeds.
OPERATION
POWER CORD
GAS O LINE PLUG
FILLER CAP
ELECTRIC
START
BUTTON
CHUTE
DE FLEC TOR
DISCHARGE
CHUTE
CLEAN-OUT TOOL
AU GERS
FIG. 10
AUGER
CONTROL
LEVER
DISCHARGE
CHUTE
CONTROL
LEVER
LIGHT
TOOLBOX
DRIFT
CUTTER
SKID PLATE
Drive speed control lever - used to select forward or
reverse motion and speed of snow thrower.
Traction drive control lever - used to engage power-
pro pelled for ward or reverse motion of snow thrower.
LH and RH turn triggers - used to steer the snow thrower.
Auger control lever - used to engage auger motion (throw
snow).
Discharge chute control lever - used to change the di-
rec tion the snow is thrown.
Skid plate - used to adjust height of scraper bar from the
ground.
Drift cutter - used to cut through deep snowdrifts.
9
DRIVE SPEED
CON TROL LEVER
DEFLECTOR
REMOTE
CONTROL LEVER
LH TURN
TRIGGER
TRACTION DRIVE
CONTROL LEVER
HANDLE
KNOB
MUF FLER