System Management And Default Settings - TRENDnet TV-IP320PI User Manual

TRENDnet User's Guide
Access your Camera with the Web Browser

System Management and Default Settings

It is recommended that you install your camera with the CD that comes with
the package and use accompanying TRENDnetVIEW Pro software (version
2.4.3 or later) for Windows computers. The software is included on the CD
comes with the package. If you do not have the CD with you, you can go to
http://www.TRENDnet.com/support enter the model number "TV-IP320PI"
and download the software.
If you didn't go through the TV-IP320PI CD installation wizard or you have
reset the TV-IP320PI to factory defaults by pressing and holding reset button
while power on the camera and keep holding the button for over 10 seconds,
your TV- IP320PI has following settings:
System Default
Management Dynamic assigned if there's a DHCP server on the
IP
network or self-assigned 192.168.10.30
Administrator admin
name
Administrator admin
password
If you want to access your camera directly instead of using software, you can
follow the steps specified in this chapter to login to your camera. A web
browser plug-in must be installed to watch video smoothly.
For Windows system, please go to the next paragraph.
For OS X system, please go directly to page 15
© Copyright 2014 TRENDnet. All Rights Reserved.
Logging-in to the Camera for the First Time (Windows)
1. Open the web browser on your computer. In the address bar, enter the
IP address you setup through the setup CD or 192.168.10.30.
(If you have a DHCP server on your network, the IP address will be
assigned dynamically. For example, if you have a home gateway on your
network and you plug-in the camera on the same network, you can find
the camera's IP address on your home gateway.), and then press Enter.
2. Enter the user name, admin, and the password you setup through the
setup CD or the default password, admin, and then click OK.
TV-IP320PI
12