After Starting - Jeep Wrangler 2009 Owenrs Manual

280 STARTING AND OPERATING
If the engine shows no sign of starting after two 15–
second periods of cranking with the accelerator pedal
held to the floor, repeat the "Normal Starting" or "Ex-
treme Cold Weather" procedures.
With Tip Start — Automatic Transmission Only
If the engine fails to start after you have followed the
"Normal Starting" or "Extreme Cold Weather" proce-
dures, it may be flooded. To clear any excess fuel, push
the accelerator pedal all the way to the floor and hold it.
Then, turn the ignition switch to the START position and
release it as soon as the starter engages. The starter motor
will disengage automatically in 10 seconds. Once this
occurs, release the accelerator pedal, turn the ignition
switch to the LOCK position, wait 10 to 15 seconds, then
repeat the "Normal Starting" procedure.
CAUTION!
To prevent damage to the starter, wait 10 to 15 sec-
onds before trying again.

After Starting

The idle speed will automatically decrease as the engine
warms up.
WARNING!
Do not leave children or animals inside parked
vehicles in hot weather. Interior heat buildup may
cause serious injury or death.