Table of Contents
Advertisement
Tool No.
Sheave fixed block
90890-04135
This tool is needed when removing or
YM-04135
installing the secondary sheave
spring.
Flywheel puller
90890-01404
YM-01404
These tools are needed to remove
the rotor.
Damper rod holder (30 mm)
90890-01327
This tool is needed to loosen and
YM-01327
tighten the steering stem bearing
retainer.
Oil filter wrench
90890-01426
YU-38411
This tool is needed to loosen or
tighten the oil filter cartridge.
Ring nut wrench
90890-01430
This tool is needed to removing and
YM-38404
installing the middle driven shaft
bearing retainer.
Gear lash measurement tool
90890-01467
YM-01467
90890-01475
This tool is used to measure the gear
YM-01475
lash.
Ball joint remover/installer set
90890-01474
YM-01474
This tool is used to remove and install
the ball joint.
Ball joint remover/installer attachment
set
YM-01477
This tool is used to remove and install
the ball joint.
Sheave holder
90890-01701
This tool is needed to hold the
YU-01880
primary sheave when removing or
installing the sheave bolts.
www.SmallEngineDiscount.com
Tool name/How to use
Not For Resale
1 - 13
SPECIAL TOOLS
Illustration
GEN
INFO
Advertisement
Table of Contents
Troubleshooting
