Hoover PurePower User Instructions page 6

Dust_Manager_6.eps Dust_Manager_6.eps 19/10/05 19/10/05 17:16:31 17:16:31
Page_06.ai 22/3/05 3:36:04 pm
C H A N G I N G B E LT O R B RU S H E S
1 2 IMPORTANT: Switch cleaner off and
remove plug from electricity supply before
checking the brushes or removing hood.
If your cleaner is not picking up efficiently, the
belt or brushes (or both) may need replacing,
but first make sure you have:
•
Emptied the dust container
•
Cleaned filters
•
Checked for blockages
b
C
M
a
1
Y
CM
Remove hood
•
Prise off carpet-care control knob
MY
•
Remove hood screws A and B
CY
Lift off hood
CMY
K
2
Remove brush assembly
•
Inspect belt for signs of wear.
•
To remove, pull brush cleaner assembly
upwards out of cleaner housing. Remove belt
from motor spindle then from brush assembly.
Replace belt
•
Loop the new belt around
the motor spindle
then around the brush
channel.
3
Refit brush assembly
•
Hold the brush assembly
and stretch the belt until
brush mountings slot down
into the cleaner housing
Rotate the brush to ensure
free movement of the belt.
4
Refit hood
•
Refit hood, ensuring the
lugs along the front of
hood are located in the
slots along the front edge
of baseplate.
•
Secure hood, using screws
A and B.
5
Refit carpet-care control
knob
•
Ensure the raised face (T) is
towards the front of the
cleaner.
Removing a blockage from the 'Pet hair remover'
(Certain models only)
Open clip and lift cover
to remove blockage.
-6-
C L E A R I N G A B L O C K AG E
!
IMPORTANT: Switch the cleaner off
and remove the plug from the
electricity supply before dismantling
cleaner.
This cleaner is unlikely to become blocked, except
by overfilling of the dust container or accidentally
picking up large solid objects. Clearing a blockage is
simple.
If cleaning tools were in
use, check cleaning tool
and extension tube first.
Next check hose
handgrip; to remove grip
ribbed ring as shown,
turn in direction of
arrow and ease apart.
To check the hose, stretch it
to full length and switch on
the cleaner; the suction will
dislodge most obstructions.
If this is unsuccessful, switch
off and unplug the cleaner.
Remove the hose by turning
it anti-clockwise as shown.
Detach cassette and remove
blockage.
For blockages in cleaner base:
1.Turn the cleaner
over and check that
the brushes are
free to rotate.
2. Check for a
blockage in hose
socket. Use a
piece of wire or a
blunt flexible rod
to remove any
obstructions.