Switching On And Off - Hoover PurePower User Instructions

Pure Power-ok 2004.4.16 10:55 AM
P R E PA R I N G TO U S E YO U R C L E A N E R
1 Insert handle into body of cleaner. Slide into
position.
Ensure handle is flush with body of cleaner.
Tighten large screw (pre-fitted to handle
upper hole). Insert small screw into handle
lower hole and tighten.
2 Locate hose end, turn clockwise to lock.
3 Locate hose retainer on lower hose support.
4 Position hose over hose supports
Push handgrip firmly into socket.
5
Clip tools to back of cleaner.
Check that paper bag is fitted, if not fit new
one (See 'Changing the paper bag' overleaf).
P OW E R S W I T C H S E T T I N G S

Switching on and off

Push bottom of switch to switch on.
Push top of switch to switch off.
Page 4
2
1
C A R P E T H E I G H T S E L E C TO R
The carpet height selector raises or lowers the height of
the nozzle.The nozzle height will not change until the
handle is released.Try various settings until you get the
best results for each of your carpets.
3
!
Ensure that cleaner
is in the upright
4
(parked position).
Slide knob to position
best suited to depth
of carpet pile.
Using this cleaner for
carpets with pile greater than
30mm is not recommended.
5
-4-
IMPORTANT: When cleaning hard floors
such as vinyl or linoleum, move the "Height
Right" selector knob to the hard floor
position. Failure to do so may cause
damage to the floor surface.
H A N D L E L O C K R E L E A S E
Unlock the handle by pressing
down on pedal with foot.
For cleaning under low
furniture and some
maintenance tasks
simply press
pedal again and
lower handle
to floor.