There are two methods for marking
waypoints.
• Basic (to select your current position)
• Advanced (to input desired destinations)
Basic Waypoint Selection
To Mark Your Present Position:
1. You may mark your position with the
engine ON – or with the engine off and the
safety lanyard lock clip inserted in the
engine stop button/switch.
2. Use the mode select button to select the
GPS mode.
3. To select a higher waypoint number (1),
press and release the + (plus) button (2).
To select a lower waypoint number, press
and release the – (minus) button (3).
To fast scroll, press and hold the + (plus)
button or – (minus) button until the desired
waypoint number appears.
4. Press and hold the WP SET button (4) for
about 1.5 seconds, until the waypoint
number and distance to waypoint (5)
flashes. Then release the button.
(2)
(3)
(4)
(1) waypoint number
(4) WP SET button
(2) + (plus) button
(5) distance to waypoint
(3) – (minus) button
GPScape System
GPS Mode
(1)
(5)
(cont'd)
79