3. Stop the flushing.
NOTICE
Avoid running the engine without water flow
for more than 15 seconds to prevent severe
engine and exhaust system damage.
4. Stop the engine and wait 2 – 3 minutes.
5. Remove both seats (page 158).
This procedure continues with Step 6 on page
170.
Engine Oil & Filter
To check the oil level on calm water
1. Start the engine.
2. Warm up the engine at approximately 4,000
rpm for 5 minutes.
If the air temperature is below 50°F (10°C),
let the engine idle for an additional 5
minutes (a total of 10 minutes).
3. Let the engine idle for a minute.
4. Stop the engine, wait 2 – 3 minutes and get
off your PWC.
5. Remove both seats (page 158).
Servicing Your Honda
(cont'd)
169