Table of Contents
Advertisement
The following table describes the parameters of this page:
Field
System Time
NTP Configuration
State
Primary Server
Secondary Server
Time Zone
3.8 Diagnostic
In the navigation bar, click Diagnostic. The Diagnostic page that is displayed
contains Ping, ATM Loopback, ADSL and Diagnostic Test.
3.8.1 Ping
Choose Diagnostic > Ping. The page shown in the following figure appears.
The following table describes the parameter and button of this page:
Field
Host
Run Ping
Set the system time manually.
Select enable or disable NTP function. You need
to enable NTP if you want to configure the
parameters of NTP.
Set the primary NTP server manually.
Set the secondary NTP server manually.
Choose the time zone in which area you are from
the drop down list.
Enter the valid IP address or domain name.
Click it to start to Ping.
- 86 -
Description
Description
Advertisement
Table of Contents
