Table of Contents
Advertisement
3.6.5 SNMP
Choose Advance > SNMP, the page shown in the following figure appears. You
can configure the SNMP parameters.
The following table describes the parameters of this page:
Field
Enable SNMP
Trap IP Address
Community Name
(Read-only)
Community Name
(Read-Write)
Select it to enable SNMP function. You need to
enable SNMP, and then you can configure the
parameters of this page.
Enter the trap IP address. The trap information is
sent to the corresponding host.
The network administrators must use this password
to read the information of this router.
The network administrators must use this password
to configure the information of the router.
- 79 -
Description
Advertisement
Table of Contents
