3.6.2.1 Static Route
Click Static Route in the left pane, the page shown in the following figure appears.
This page is used to configure the routing information. You can add or delete IP
routes.
The following table describes the parameters and buttons of this page:
Field
Enable
Destination
Subnet Mask
Next Hop
Metric
Interface
Add Route
Update
Select it to use static IP routes.
Enter the IP address of the destination device.
Enter the subnet mask of the destination device.
Enter the IP address of the next hop in the IP route to the
destination device.
The metric cost for the destination.
The interface for the specified route.
Click it to add the new static route to the Static Route
Table.
Select a row in the Static Route Table and modify the
Description
- 71 -