Table of Contents
Advertisement
The following table describes the interfaces of the device:
Interface/Button
WPS/WLAN
ADSL
LAN4/3/2/1
Power
Reset
1.4 System Requirements
Recommended system requirements are as follows:
A 10/100 base-T Ethernet card is installed on your PC
A hub or Switch. (connected to several PCs through one of Ethernet
interfaces on the device)
Operating system: Windows 98SE, Windows 2000, Windows ME, Windows
XP
Internet Explorer V5.0 or higher, Netscape V4.0 or higher, or Firefox 1.5 or
higher
Press the button silently less than 1s to enable
WLAN function.
Press the button for more than 5s to enable WPS
function.
If you press the button between 1s and 5s, no function
takes effect.
RJ-11 interface, for connecting to the ADSL interface or
a splitter through a telephone cable.
RJ-45 interface, for connecting to the Ethernet interface
of a PC or the Ethernet device through an Ethernet
cable.
Power interface for connecting to the power adapter of
12 V DC ,1A.
Power switch, power on or off the device.
Reset to the factory defaults. To restore factory defaults,
keep the device powered on and insert a
the hole for over 8 seconds and release.The device is
reset to the factory default configuration.
- 6 -
Description
needle into
Advertisement
Table of Contents
