Installation - Klutch MIG 140Si Owner's Manual

2.6 Connect the gas connection quick connector to the gas connector (1) on the back panel of the
wire compartment.
2.7 Connect the weld power connection to the bolt on the top of the MIG connector (2).
2.8 Connect the 5-Pin trigger connector to the 5-Pin receptacle on the front of the machine (3).
2.9 Make certain the SPOOL GUN/MIG TORCH SELECTOR on the front panel is switched into
the SPOOL GUN position.

INSTALLATION

1. POWER REQUIREMENT - AC single phase 115V (110-120V) 60 HZ fused with a 20 amp time
delayed fuse or circuit breaker is required. DO NOT OPERATE THIS UNIT if the ACTUAL power
source voltage is less than 105 volts AC or greater than 132 volts AC.
Electrical Shock

High voltage danger from power source! Consult a qualified electrician for proper
installation of receptacle. This welder must be grounded while in use to protect the
operator from electrical shock.

Do not remove grounding prong or alter the plug in any way. Do not use any adapters
between the welder's power cord and the power source receptacle. Make sure the
POWER switch is OFF when connecting your welder's power cord to a properly
grounded 115 VAC, 60 HZ, Single Phase, 20 Amp input power supply.
2. EXTENSION CORD - We do not recommend an extension cord because of the voltage drop they
produce. This drop in voltage can affect the performance of the welder. If you need to use an
extension cord, it must be a size #12 or larger. Check with a qualified electrician and your local
electrical codes for your specific area. Do not use an extension cord over 25 ft. in length.
Page 11 of 27