Major Science MS 250V Instruction Manual page 7

using the power cord provided with the power supply.
Avoiding Damage to the Instrument
1. Do not attempt to operate the device if it is damaged.
2. Protect this unit from physical damage, corrosive agents and extreme
temperatures (direct sunlight etc).
3. For proper ventilation and safety concerns, keep at least 10 cm of space
behind the instrument, and at least 5 cm of space on each side.
4. Do not operate the power supplies in high humidity environments (> 95%),
or where condensation may occur.
5. When the power supply series is taken into a cold room environment, the
unit can be operated immediately. However, when the power supply series is
removed from the cold room environment, let the unit equilibrate to room
temperature for a minimum of 2 hours before using it.
6. Prior to apply any cleaning or decontamination methods other than
manufacturer's recommendation, users should check with the
manufacturer's instruction to confirm if the proposed method will not damage
the equipment.
Equipment Operation
Follow the guidelines below to ensure safe operation of the unit:
1. It must be checked the displayed figure to see if it is in the normal condition
for use before using this unit.
2. NEVER access dangerous chemistry or other material to prevent possible
hazards of explosion and damage.
Symbols
The symbols used on MS 250V / MS 300V Power Supply are explained below.
Used on MS Power Supply to indicate an area where a potential
shock hazard may exist.
Used on MS Power Supply to indicate a warning. Consult the manual
to avoid possible personal injury or instrument damage.
Used on MS Power Supply to indicate a disposal instruction.
DO NOT throw this unit into a municipal trash bin when this unit has
reached the end of its lifetime. To ensure utmost protection of the
global environment and minimize pollution, please recycle this unit.
6