Suzuki LT-A750XP/Z Supplementary Service Manual page 106

6C-37 Power Assisted Steering System:
Step
2 1) Turn the ignition switch OFF.
2) Connect the torque sensor coupler.
3) Insert the needle-point probes to lead wire coupler.
4) Turn the ignition switch ON.
5) Measure the voltage between W wire "A" and B wire "B"
by turning the handlebars left and right.
Special tool
(A): 09900–25008 (Multi circuit tester set)
(B): 09900–25009 (Needle-point probe set)
Tester knob indication
Voltage ( )
Torque sensor (Sub) voltage
Handlebars is left turn: Approx. 2.0 V
Handlebars is right turn: Approx 3.0 V
Is voltage OK?
Action
(A)
(B)
"A"
"C"
"B"
(B)
(B)
Yes
• Replace the EPS
control unit with a
known good one, and
inspect it again. Refer
to "EPS Control Unit
Removal and
Installation (LT-
A750XP/ZK9)
(Page 6C-48)".
I931G3630030-02
I931H1630042-01
No
• R wire terminal or W
wire terminal circuit
open (torque sensor
side).
• If check result is not
satisfactory, replace
the torque sensor
(EPS body assembly)
with a new one. Refer
to "Steering Shaft
Removal and
Installation in Section
6B in related
manual".