Replacing The Heat Exchanger Unit - Miele PT 5135 C Operating And Installation Instructions

^ Then flush the unit through from the
front.
^ Check the heat exchanger unit again
for any visible fluff and if necessary
flush it through again until it has all
gone.
^ Shake any excess water out of the
unit until no more water droplets are
visible.
^ Remove any soiling still visible inside
the housing unit by hand using and
damp cloth. Do not try and access
areas you cannot reach by hand!
^ Also make sure the rubber seals are
clean.
The rubber seals must not be
removed and must be free of kinks.

Replacing the heat exchanger unit

^ With the handle facing upwards,
push the heat exchanger unit back
into position in its housing.
^ Turn the lever down to the horizontal
position, making sure that the hook
on the lever clicks into the groove.
Cleaning and care
When replacing the cover after
cleaning, ensure that the rubber seal
fits correctly into the groove.
^ Replace the cover making sure the
hooks locate correctly. Hold it at an
angle and push it gently downwards.
^ Then turn the lever upwards into the
horizontal position to lock the cover.
^ Replace the service panel and press
the upper edge until it clicks into
position.
,
It is important to ensure that both
the heat exchanger unit and the
cover are correctly positioned and
locked otherwise water may leak
from the machine.
27