Foot Platform Height Adjustment; Foot Platform Angle Adjustment; Swing-Away Footrests - Pride JAZZY 1113 ATS Owner's Manual

V . C O M F O R T
5. Slide the controller out of the armrest and place it in the
other armrest.
6. Tighten the setscrew.
7. Use a wire tie to secure the controller harness to the
armrest.
8. Plug the controller connector(s) into the power base.
NOTE: If your power chair is equipped with a Synergy
Seating System or Synergy Tru-Balance Power
Positioning System, refer to the controller adjustment
information provided in separate manuals.

Foot Platform Height Adjustment

The foot platform height is easily adjusted to different
heights in 1-2-in. (2.54-5.08 cm) increments.
To raise or lower the foot platform:
1. Remove the hardware from the foot platform bracket. See
figure 25.
2. Raise or lower the foot platform to the desired height.
3. Reinstall the hardware into the foot platform bracket and
tighten.

Foot Platform Angle Adjustment

You can adjust the angle of the foot platform with a hex key and
wrench.
To adjust the foot platform angle:
1. Flip up the foot platform and locate the setscrew. See
figure 26.
2. Loosen the nut and turn the setscrew to raise the front
of the foot platform or to lower the front of the foot
platform.
3. Tighten the nut to secure the setscrew.

Swing-Away Footrests

Swing-Away Footrests (SFRs) enable you to rotate the foot-
rests to the side before you transfer onto or off of your power
chair. See figure 27.
To rotate the SFRs:
1. Push in the release lever.
2. Rotate the SFRs.
28
A D J U S T M E N T S
Figure 26. Foot Platform Angle Adjustment
www.pridemobility.com
FOOT PLATFORM BRACKET
Figure 25. Foot Platform Height Adjustment
FOOTREST
EXTENSION
Figure 27. Swing-away Footrest Adjustment
SETSCREW
SFR RELEASE LEVER
ADJUSTMENT
SCREWS
Jazzy 1113 ATS