Jazzy 1113 Ats Component Assemblies - Pride JAZZY 1113 ATS Owner's Manual

I V . D I S A S S E M B L Y A N D A S S E M B L Y
6. Route the controller cable so that it cannot be pinched in the seat hinge and plug the cable into the controller connector
on the electronics tray.
MANDATORY! Prevent controller harness damage! Use correct tie-down points for controller
harness.
7. Secure the controller cable to the armrest receiver with one or more wire ties.
DISASSEMBLY
Your power chair disassembles into eight easily transportable component assemblies with no tools required. See figures 13
and 14. Place the power chair in an area where there is ample space to work and move around the unit—3 feet (1 meter)
of clearance on all sides. Make sure the unit is powered off before disassembling the chair.
WARNING! Even though no tools are required to disassemble or assemble your power chair, you
should take care not to place your hands or fingers on the areas of the component assemblies
where they may be pinched, as the assemblies "snap" together or "snap" apart.
WARNING! Some power chair components are heavy. You may need assistance to lift or carry
them. Please refer to the specifications table for specific component weights before you
disassemble the power chair.
NOTE: During both the disassembly and the assembly of your power chair, you may find it helpful to engage
the drive motors to secure the unit from rolling. See III. "Your Power Chair."
BATTERY WELL
FRAME
RIGHT POWER BASE
FRAME ASSEMBLY
Figure 13. Jazzy 1113 ATS Component Assemblies
20
BATTERY BOXES
www.pridemobility.com
LEFT POWER BASE
FRAME ASSEMBLY
FOOT PLATFORM
FRONT FRAME
Jazzy 1113 ATS