Siemens C300H User Manual page 14

A Gigaset C300H handset can be registered on up to four bases.
Once the registration process has been completed successfully, the handset returns
to idle status. The handset's internal number is shown in the display e.g., INT 2. If
not, repeat the procedure.
For instructions on deregistering the handsets, please consult the base user
guide.
Initial charging and discharging of the batteries
The correct charge status can only be displayed if the battery is first fully charged
and then discharged.
¤ Charge the handset in the charger for 7.5 hours.
The handset must only be placed in the designated Gigaset C300/C300A base
or charger.
¤ After charging, remove the handset from the charger and only replace it when
the batteries are fully discharged.
u After the first battery charge and discharge, you may place your handset in
the charger after every call.
u Always repeat the charging and discharging procedure if you remove the
batteries from the handset and reinsert them.
u The batteries may warm up during charging. This is not dangerous.
u After a while, the charge capacity of the batteries will decrease for technical
reasons.
www.InternetVoipPhone.co.uk | sales@internetvoipphone.co.uk | 0800 088 4846
Please note
Please note
Please note
Taking the first steps
7.5hrs
13