Quick Spin Test; Hold Quick Spin Step; Fast Time Down Test - Maytag MAH8700AW* Service

Troubleshooting Procedures
To avoid risk of electrical shock, personal injury or death, disconnect power to unit before servicing, unless testing
requires power.
Test or Display
Press LED to
Hold Quick Press
Rinse&Spin
Service Cycle
and Spin Only
Step
together
Press Delay for
3 seconds (then
individual
buttons to test)
Rotate Cycle
LED/Switch
Selector
Test
clockwise, the
LED's around it
will be toggled.
Rotate
counterclockwis
e, the7-
segment LED's
toggle. Press
Rotary Cycle
Selector, all of
the LED's
around the
Rotary Cycle
Selector will be
toggled.
Board Press Spin
IN
Only
Input
Test
Board Press Spin
Speed
Output
Test /
System Check
Press Rinse&
Spin – displays
"d"
Diagnostic
Code Display
(Initial)
All Diagnostic Rotate Cycle
Selector either
Codes
direction
Press and hold
Cycle Count
Rotary
No. for
Selector, while
Diagnostic
diagnostic code
Code
is displayed
Press Delay
Clear All
and Chime
Diagnostic
together while
Codes
displaying
diagnostic
codes
14
!
Press LED to
Start Cancel
Press
Rinse&Spin
and Spin Only
to resume
Press Off twice
after starting
test
Press Spin
Only
Press Off
Press
Rinse&Spin
again
N/A
Release Rotary
Selector
(returns to
diagnostic code
display)
16026126 Rev. 0
WARNING
Test or Display
Display
Software
Version
Cycle Count

Quick Spin Test

While in Service Mode, press Delay and
Rinse&Spin keys to start a Quick Spin
Test. Quick Spin test steps are as
follows:
•
Start spinning and after reaching a
maximum spin speed.
•
stay at maximum spin speed for 2
minutes and stop Quick Spin Test.

Hold Quick Spin Step

If the Rotary Selector key is pressed during
the Quick Spin test, the machine will hold at
the next highest index speed for up to 10
minutes. At the end of 10 minutes, the
machine will resume and finish the Quick
Spin test. To cancel the Hold and allow the
Spin Test to continue, press the Delay and
Rinse&Spin keys.

Fast Time Down Test

While any test or cycle is running in
Service Mode, pressing the Temperature
key will advance the program to the next
cycle stage.
Cycle stages are located at key locations in the
machine operation. As the program is advanced it
will index as follows: The end of each fill (the
same as the beginning of a tumble session for
Wash, or Rinse); at the beginning of a drain
session; at the beginning of a spin session (at this
position, check the water level, if over reset level,
drain first before entering the spin function); at the
beginning of a fill session; at the beginning of
Press LED to Press LED to
Start Cancel
Press Soil Press Soil
Level. Press 2 Level a 3
times for
displays with
only 2 character
positions.
Press Chime
©2005 Maytag Services
rd
time