Advertisement
TOYOTA 4Runner 1996-99
1
Disconnect the negative battery terminal to
prevent an accidental short circuit. Open
the center armrest door.
Unsnap the
parking brake trim panel to access the gear
shifter trim panel. Unsnap the gear shifter
trim panel and remove. Remove the climate
control knobs. Remove the climate control
trim plate and (2) Phillips screws exposed.
Unclip the radio trim bezel and remove.
Remove (4) Phillips screws securing the
factory head unit and disconnect the wiring.
TOYOTA Camry 1987-91
1
Disconnect the negative battery terminal to
prevent an accidental short circuit. Remove
(2) screws above the climate controls and
gently unsnap the dash trim bezel. Remove
(4) screws securing the factory head unit
and disconnect the wiring.
2
2
Remove the mounting brackets from the
factory head unit assembly. Align the holes
in the mounting brackets with the holes in the
Mount the factory mounting
Pocket.
brackets to the Pocket with those screws
previously removed.
2
Remove the mounting brackets from the
factory head unit assembly. Align the holes
in the mounting brackets with the holes in the
Pocket.
Mount the factory mounting
brackets to the Pocket with those screws
previously removed.
TOYOTA Celica (GT/GTS) 1986-89
1
Disconnect the negative battery terminal to
prevent an accidental short circuit. Remove
(2) screws from the lower steering column
panel and remove. Remove the (2) screws
exposed on the radio trim bezel. Open the
glove box and remove (1) screw and (1) bolt
exposed. Remove (2) screws from the ash-
tray cavity and (2) screws from the bracket.
Remove (2) screws from each lower side of
the trim bezel and unsnap the bezel.
TOYOTA Celica 1990-93
1
Disconnect the negative battery terminal to
prevent an accidental short circuit. Carefully
pry up on the gear shifter trim panel and
remove. Remove (2) screws exposed on
the bottom edge of the radio trim panel.
Unsnap the panel and disconnect the
ashtray and cigarette lighter wiring.
2
Remove the mounting brackets from the
factory head unit assembly. Align the holes
in the mounting brackets with the holes in the
Mount the factory mounting
Pocket.
brackets to the Pocket with those screws
previously removed.
2
Remove the mounting brackets from the
factory head unit assembly. Align the holes
in the mounting brackets with the holes in the
Pocket.
Mount the factory mounting
brackets to the Pocket with those screws
previously removed.
3
Advertisement
