Page 1
INSTALLATION INSTRUCTIONS FOR PART 95-5026 2001-2004 Ford Mustang 2003-2006 Ford Expedition 2002-2005 Ford Explorer 2003-2006 Lincoln Navigator 2002-2005 Lincoln Aviator 2002-2005 Mercury Mountaineer 95-5026 KIT FEATURES • Double DIN head unit provision • Stacked ISO DIN head unit provision KIT COMPONENTS...
Page 2
95-5026 T ABLE OF CONTENTS Dash Disassembly ........1-5 Kit Assembly .
Page 3
95-5026 2001-2004 FORD MUST ANG Disconnect the negative battery terminal to prevent an accidental short circuit. Unclip and remove shift lever trim panel. (Figure A) Unclip and remove the entire panel surrounding the radio and climate controls including the vents.
Page 4
95-5026 2003-2006 FORD EXPEDITION Disconnect the negative battery terminal to prevent an accidental short circuit. Remove (2) 9/32” screws from above instrument cluster. (Figure A) Unclip and remove entire panel sur- rounding radio, climate controls, and instrument cluster. (Figure B) Remove (2) 9/32”...
Page 5
95-5026 DASH DISASSEMBL Y 2002-2005 FORD EXPLORER 2002-2005 MERCURY MOUNT AINEER Disconnect the negative battery ter- minal to prevent an accidental short circuit. Unclip and remove entire panel sur- rounding radio including climate con- trols and vents. (Figure A) Remove (2) 9/32” screws securing...
Page 6
95-5026 2003-2006 LINCOLN NAVIGA TOR Disconnect the negative battery ter- minal to prevent an accidental short circuit. Open center console and remove (1) push pin from back of power window switch panel. (Figure A) Unclip and remove panel. Remove (2) 9/32” screws exposed on shifter panel then unclip and move shifter panel off to side.
Page 7
95-5026 2003-2005 LINCOLN AVIA TOR Disconnect the negative battery ter- minal to prevent an accidental short circuit. Unclip and remove vent panel above radio on top of dashboard. (Figure A) Remove (2) 9/32” screws exposed under panel removed in step 1.
Page 8
95-5026 DOUBLE DIN HEAD UNIT PROVISION Slide the appropriate bracket into the trim plate aligning the holes in the trim plate to the clips on the bracket. (Figure A) Slide the DDIN radio unit into the trim plate bracket assembly and secure the unit to the kit using the screws supplied with the head unit.
Page 9
95-5026 STACKED ISO DIN HEAD UNIT PROVISION Slide the appropriate bracket into the trim plate aligning the holes in the trim plate to the clips on the bracket. (Figure A) Slide the stacked ISO DIN units into the trim plate bracket assembly and secure the units to the kit using the screws supplied with the head units.
Page 10
95-5026 FINAL ASSEMBL Y 1 Locate the factory wiring harness in the dash and make the connection as shown. Metra recomends using the proper mating adapter and making the connections as shown. (Isolate and individually tape off the ends of any unused wires to prevent electrical short circuit.)