Maintenance, Storage And Calibration; Care And Cleaning - Mobi Technologies DualScan User Manual

MAINTENANCE, STORAGE AND CALIBRATION

Maintenance:
1. Remove all stains from the device with a soft, dry cloth.
2. Clean the tip of the probe as follows: Wipe the surface gently with a swab
of cotton or a soft cloth moistened with alcohol until no dirt or wax remains.
Allow the alchol to dry before using thermometer again.
3. Do not wash the thermometer with water, abrasive detergent or detergent
containing benzene or other harsh solvents.
Storage:
1. After each use, clean the thermometer and put on the protective cover.
2. Do not leave the thermometer exposed to direct sun, high temperatures,
3. If you plan to not use the thermometer an extended time, remove the
batteries.
Calibration:
The thermometer is factory-calibrated. If it is used according to this user
manual, periodic recalibration is not required. If there are doubts concerning
the accuracy of the thermometer, please contact Mobi at the address
given herein. Do not try to repair or modify the thermometer yourself.
1. Keep the probe surface clean, otherwise the measurement may not be
accurate.
2. Clean the probe with a non-abrasive cloth or paper moistened with water
or alcohol, and conduct measurement after the water or alcohol on the
surface of the probe has evaporated.
Caution:
Make sure the probe tip of the thermometer is completely clean. A dirty
probe lens will cause inaccurate measurements.

CARE AND CLEANING

13