Code Alarm CA 170 Installation Instructions Manual page 5

SETUP & PROGRAMMING, CONTINUED
Custom Pin Code Programming
Programming your Pin Code (pin code must be two digits).
1. Turn the ignition ON.
2. Press and hold the programming button for 10 seconds, the system will chirp 3 times.
3. Advance to Feature Bank 3, (5 chirps).
4. Press and hold TRUNK button for three seconds to enter pin code programming, the siren will chirp
twice and the LED will flash twice.
5. Enter the first digit by pressing the LOCK button 1-9 times.
6. Enter the second digit by pressing the UNLOCK button 1-9 times.
7. Press and hold TRUNK button for three seconds to confirm digit entry and exit programming, the
system will give one long chirp and report entry by flashing the LED.
If the new pin code has been accepted (example pin code is 87), the unit will report back by flashing the
LED 8 times to indicate the first digit, pause and then flash 7 times indicating the second digit.
Example: If the desired pin code is 87, during step 5 you will press the LOCK button 8 times and during
step 7 you will press the LOCK button 7 times.
Note: Custom Code must be turned ON in feature bank 3 before a pin code can be programed. The
default setting for this feature is OFF.
AUX 1 Optional Timer Programming
The AUX 1 output (VIOLET/BLACK) can be programmed with 3 preset times or a programmable output
time (between 1 and 120 seconds). To set the programmable time follow the instructions below:
1. Turn the ignition ON.
2. Press and hold the valet/override button for 10 seconds, the system will chirp 3 times
3. Press and release the valet/override button 2 times to advance to Feature Bank 3 (5 chirps)
4. Press the PANIC button on the transmitter to scroll to AUX 1 output programming.
5. Press the LOCK button to scroll to "Program Time", (4) four LED flashes.
6. Press and hold the valet/override button, the timer will immediately start.
7. When the desired time has elapsed (must be between 1 and 120 seconds) release the valet/
override button. The system will sound 1 long chirp to verify programming.
5