Front Turn Indicator Lamp Bulb - Lotus 2005 Elise Owner's Handbook Manual

RELEASING FRONT TURN LAMP
High beam bulb: Disconnect the two cables from the bulb, re-
lease the spring wire clip, and withdraw the 55W H7 bulb. On re-
fitting, note that the bulb is keyed to allow only one orientation.
Parking lamp: Twist the bulb holder counterclockwise to release
from the main beam lamp, and withdraw the bayonet fitting T4
W bulb.
Front Turn Indicator Lamp Bulbs
For access to the front turn indicator bulb, the lamp unit must
be released from the body. Using a suitable stiff rod or screw-
driver blade inserted through the access hole in the outer top
corner of the air intake aperture, press back the lamp retaining
clip at the front end of the lamp, and withdraw the lamp from the
body. Twist the bulb holder counterclockwise to release from the
lamp, and replace the bayonet fitting amber bulb.
After replacing the bulb and holder, ensure the rubber seal
is correctly positioned around the lamp. Engage the tongue at
the rear end of the lamp unit with the body flange, and press the
front end of the lamp firmly down until a distinct 'click' is heard,
indicating engagement of the retaining clip. Pull up on the front
end of the lamp to check security.
Side Repeater Lamp Bulbs
The side marker lamps mounted on the front and rear
wheelarch lips, each use four longlife LEDs which are not serv-
iceable. In case of failure, the lamp unit should be replaced by
your dealer.
oh_croft_InD.indd 143
ohs149
143
20/05/2004 07:59:16