Lotus 2005 Elise Owner's Handbook Manual page 88

FRONT SPIGOT BRACKET
Hard Top - Fitting
1. Open both doors, and preferably with the aid of an assistant,
lower the roof onto the car holding aside the loose tethered
fixings to avoid their entrapment or their causing paint damage.
Position the rear edge of the roof first before locating the front
edge against the windscreen header rail.
2. Locate a front spigot bracket into its latch plate lower slot
(lifting the roof slightly to allow this) and retain to the roof with
the Torx bolt. Use only the special Torx tool supplied in the
car tool kit (stowed in the battery cover pocket), and do not
fully tighten at this stage.
3. Repeat step (2) for the opposite front spigot bracket.
86
oh_croft_InD.indd 86
b330
20/05/2004 07:59:02