Mazda L8 Workshop Manual page 34

4. Measure the journal diameters in X and Y
directions at the two points (A and B) as indicated
in the figure.
• If not as specified, replace the camshaft.
Standard diameter:
24.96—24.98 mm {0.9827—0.9834 in}
Minimum diameter:
24.95 mm {0.982 in}
5. Remove the tappet.
6. Position plasticgage atop the journals in the axial
direction.
7. IInstall the camshaft cap. (See
8. Remove the camshaft cap. (See
9. Measure the oil clearance.
• If not as specified, replace the cylinder head.
Standard clearance:
0.04—0.08 mm {0.002—0.003 in}
Maximum clearance:
0.09 mm {0.0035 in}
10. Install the camshaft cap. (See
Assembly Note)
11. Measure the camshaft end play.
• If not as specified, replace the cylinder head
or camshaft.
Standard end play:
0.09—0.24 mm {0.0035—0.0094 in}
Maximum end play:
0.25 mm {0.0099 in}
12. Remove the camshaft cap. (See
Cap Disassembly Note.)
End Of Sie
ENGINE
B–40 Camshaft Assembly
B–6 Camshaft Cap Disassembly
B–40 Camshaft
B–6 Camshaft
Note.)
Note.)
B
AME2224E344
AME2224E307
AME2224E025
B–17