Function Keys - Alexor PC9155-433/868 Installation Manual

PC9155 Wireless Alarm System
[ ][7][1 or 2] – Command Outputs (1&2)
Press [ ][7] then [1] or [2]. If the Command Output Code Required option is enabled, enter a valid user code. The panel activates a command out-
put assigned to any PGM.
[ ][8] – Installer Programming
Press [ ][8][Installer Code] to enter Installer Programming. Installer programming allows the installer to program all system functions.
Refer to the section 5: Installer Programming for details.
[ ][9][User Code] – No-Entry Arming
Press [ ][9] followed by a valid user code. The system arms in the Stay mode after the exit delay expires and removes entry delay. All zones pro-
grammed as Delay function like Instant zones. The system flashes the Armed light to indicate that it is armed with no entry delay.
[ ][0] – Quick Arm/Quick Exit
Quick Arm: When disarmed, press [ ][0] to arm the system. Quick Arm is equivalent to entering your user code.
Quick Exit: When armed, press [ ][0] to activate Quick Exit. Quick Exit allows you to exit the premises without disarming the system.The sys-
tem allows a single zone programmed as Delay to be violated and restored once during the following 2 minute time period without changing the
status of the system.

3.4 Function Keys

The keypad has 5 programmable one-touch function keys located in a column down the right-side of the keypad. These keys can also be activated
by pressing and holding number [1] through [5] respectively for 2 seconds. The default for these keys are as follows:
[1] Stay Arm
[2] Away Arm
[3] Chime Enable/Disable
[4] Bypass
[5] Quick Exit
3-4