Dls Programming; Installer Programming - Alexor PC9155-433/868 Installation Manual

PC9155 Wireless Alarm System
Digit 4 indicates/selects one of the following DLS connections:
Double Call
Option
Sect [401] Opt 1
1
2
3
4

4.2 DLS Programming

4.2.1 Local Programming with PC-Link
Follow the steps below in the sequence indicated.
Step
Ensure front cover is removed and the system is powered up.
1
i
PC-Link connections are 'hot-swappable'. GPRS/Ethernet module connections are not 'hot-swappable'
and the PC9155 should be powered down before connecting or disconnecting this module.
Step
For systems with a GS2065 or TL265GS module installed, disconnect the PC-link connector from the PC9155
2
module side first.
Step
Connect the PC-Link cable between the computer (with DLS Software installed and running) and the header pins
3
on the alarm system.
Connecting the DLS PC to the alarm system automatically initiates a DLS session.
If the DLS session is not automatically initiated, enter [ ][8][Installer Code][499][Installer Code][499] to
manually initiate PC-Link (Refer to the DLS software help file for programming details).
Upon completion of the session, remove the PC-link cable from the alarm system, power down, and reconnect the
cable for the GPRS/Ethernet module (if installed).
4.2.2 Remote Programming via Telephone Line
Refer to section [401] DLS Downloading for setup details.
i
After downloading a 2-way wireless key serial number to the PC9155, a button must be pressed on the wireless
key before it will become operational.

4.3 Installer Programming

Enter [ ][8][Installer Code].
The system prompts for a 3-digit programming section number (refer to Chapter 5 for programming details).
Call Back User Call Up
Sect [401] Opt 3 Sect [401] Opt 4
#Rings
Sect [406]
000
008
008
008
4-4