Installa On Of Ven Ng (Indoor Models Only) - Rinnai REU‐VC2528FFUD‐US Installation And Operation Manual

Installa on of ven ng (indoor models only)
Install the correct ven ng for your model according to the ven ng manufacturer's instruc ons and the
guidelines below.
Refer to the manufacturer's technical literature for specific part numbers and instruc ons.
Listed and Tested Vent Products
Manufacturer
Ubbink
Heat‐Fab
Metal‐Fab Corr/Guard Vent/Air Intake System
Ven ng Guidelines
DO NOT
•
Do not use PVC, CPVC, ABS or galvanized material
to vent this appliance.
•
Do not combine vent components from different
manufacturers.
•
Vent diameter must not be reduced.
•
Do not connect the ven ng system with an
exis ng vent or chimney.
•
Do not common vent with the vent pipe of any
other water heater or appliance.
MUST DO
•
This water heater is a direct vent water heater and
therefore is cer fied and listed with the vent
system. You must use vent components that are
cer fied and listed with the water heater model.
•
The vent system must vent directly to the outside
of the building and use outside air for combus on.
•
Avoid dips or sags in horizontal vent runs by
installing supports per the vent manufacturer's
instruc ons.
•
Support horizontal vent runs every four feet and
all ver cal vent runs every six feet or in
accordance with local codes.
•
Ven ng should be as direct as possible with a
minimum number of pipe fi ngs.
•
Vent connec ons must be firmly pressed together
so that the gaskets form an air ght seal.
•
The vent piece connected to the water heater
must be secured with one self‐tapping screw.
for RL75i and RL94i
Rolux Vent System
Saf‐T Vent SC system
Telephone
800‐621‐9419 678‐829‐1666
800‐772‐0739 413‐863‐4803
800‐835‐2830 316‐943‐2717
INFORMATION
•
Refer to the instruc ons of the vent system
manufacturer for component assembly
instruc ons.
•
If the vent system is to be enclosed, it is suggested
that the design of the enclosure shall permit
inspec on of the vent system. The design of such
enclosure shall be deemed acceptable by the
installer or the local inspector.
NOTICE
If it becomes necessary to access an enclosed vent
system for service or repairs, Rinnai is not responsible
for any costs or difficul es in accessing the vent
system. The warranty does not cover obtaining
access to a vent system in an enclosed environment.
VC Series Manual
Fax
www.rinnai.us
custsvc@heat‐fab.com,
www.hea ab.com
info@mtlfab.com,
www.metal‐fabinc.com
Contact
13