Philips Selecon PL1 Series Installation & User Manual page 19

PL1 LED Luminaires
General
1
1
3
3
Presets
3
3
DMX
3
1
2
2
Fan
3
3
3
Display
3
Note: To Exit the Settings screen, use the [ESC] key. [ESC] and [OK] can be used to cancel or save changes to an
individual parameter. However, once a parameter has been accepted, by pressing [OK] that change cannot be undone/
canceled by pressing the [ESC] key.
30W, 40W, 50W, 70W,
Power Limit
90W, 100W, 120W
Off, Scratch Pad,
Warm White, Cool
Power-Up White, Day Light,
Preset30, Preset31,
IR Enabled
Reset Hours
Protected
Load Factory
No, Yes, or Wireless (if
DMX Enabled
Address
Map 8-bit, 16-bit, or 3-Chan
Off, Hold, Hold 8hr (8
When no DMX
hours), or Power-Up
Normal / Quiet Normal or Quiet
Max%
Min%
Flip Display
120W
Cool White
Last Set
No, Yes Yes
No, Yes No
No, 5 - 25 Yes
No, Yes No
Yes
equipped)
001 to 512 001
16-bit
Hold
Quiet
0 to 100% 100
0 to 100% 1
No, Yes No
Installation & User's Manual
Sets the maximum power setting of the
LED engine.
When the Fixture Powers-Up what does it
output. Scratch Pad is an automatically
saved Preset. Last Set is the last thing
coming out of the fixture, this could be
Warm White with the intensity changed
from that of the Preset.
Turns IR/Laser detection On/Off
Resets luminaire's operational hours.
Determines if the factory Calibrated
Presets' Color Mix is protected from
changes.
Reload Factory Calibrated Presets,
Intensity changes will also be reloaded.
Enables or disabled DMX communication
through the luminaires DMX512 ports.
Sets the DMX feature to Wireless DMX (if
wireless DMX option is installed - sold
separately).
DMX512 address. Note, it can be set if
displayed.
Defines size/precision of DMX map. Color
Mixing/Intensity in 16-bit provides higher
resolution for precision control. 3-Chan
provides minimal channel usage.
If DMX is detected and then goes away,
this defines what will happen to the output.
At end of 8Hr hold Fixture goes to Power-
Up setting.
Normal - Normal Mode Provides higher
cooling margin for thermally challenging
applications. Recommended for full power
(RGBW @ 100%) applications with large
and numerous changes in power. Quiet -
(Quiet Mode) Quite Mode is similar to
Normal mode, but it controls fan tightly to
reduce fan noise.
Sets the maximum fan speed
Sets the minimum fan speed
Flips (inverts) Display and Keypad Arrows.
Settings
17