Mazda 6 2006 Owner's Manual page 195

A new CD may have rough edges on
l
its inner and outer perimeters. If a disc
with rough edges is used, proper
setting will not be possible and the In-
dash CD changer will not play the CD.
Remove the rough edges in advance by
using a ball-point pen or pencil as
shown below. To remove the rough
edges, rub the side of the pen or pencil
against the inner and outer perimeter of
the CD.
When driving over uneven surfaces,
l
the sound may jump.
The In-dash CD changer has been
l
designed to play CDs bearing the
identification logo as shown. No other
discs can be played.
Be sure never to touch the signal
l
surface when handling the CDs. Pick
up a CD by grasping the outer edge or
the edge of the hole and the outer edge.
Do not stick paper or tape on the CD.
l
Avoid scratching the reverse side (the
side without a label).
Dust, finger smudges, and dirt can
l
decrease the amount of light reflected
from the signal surface, thus affecting
sound quality. If the CD should
become soiled, gently wipe it with a
soft cloth from the center of the CD to
the edge.
Do not use record sprays, antistatic
l
agents, or household spray cleaners.
Volatile chemicals such as benzine and
thinner can also damage the surface of
the CD and must not be used. Anything
that can damage, warp, or fog plastic
should never be used to clean CDs.
CD TEXT textual information cannot
l
be displayed by audio units other than
the In-dash CD changer (MP3 support
type only). (Only playback is possible.)
The following player can play MP3
l
files recorded in CD-ROM, CD-R, and
CD-RW.
· In-dash CD changer (MP3 file
support type only)
Interior Comfort
Audio System
6-15